Review on King & Charles Cabinet Hardware Jig for Better SEO: Cabinet Handle & Drawer Pull Template Tool for Handles and Pulls by Tabish Jadhav

I had to install appliances in my new house that required no effort. It would be very difficult without this tool. A quick note: the included drill bit and center punch are smaller than the drill guides. The bit is 4.2mm and the punch is 4mm. Sleeve 5mm. I didn't have a 5mm drill, but a 3/16" drill worked great. I recommend simply using the 3/16" bit in the drill to make the first hole/tap with the template, then remove the template and finish drilling the hole. If I did this for a living I would buy something stronger. But for my use it was great for only $20. For drawers wider than the end cap can span I changed the stopper in the photo. I drew a line with the center slot in the center piece and drilled a peep hole so I can see through a piece of tape, marking the top of the drawer panel centered.