Review on Honeywell RWD80/A1 Water Defense Water Sensing Alarm Extension Cable: Ensure Enhanced Protection with this Effective Accessory by John Koch

Seems I'm not the only one with this idea. Viewing the reviews shows several different options for this solution. In my case I have a Raspberry Pi with HomeBridge. Using GPIO 5VDC, GND and I/O pin. I am connected to the YL-38 module. I then convert its control pins to (female) ethernet. If you're familiar with any of the things I just mentioned, you're the target audience for this review. SUPER EASY installation. As. No joke. Insanely easy. The humidity sensor cable uses a 4-wire cable. Middle pair and outer pair. PINOUT cable uses Ethernet connectors and 568B wiring: First pair (1): Switch to GREEN/WHITE and GREEN Pair two (2): Switch to BLUE/WHITE and BLUE Use the adjustment potentiometer on YL-38 to switch set the sensitivity and you're done*. You also need to set up your R Pi. I put two YL-38s in one case (with the same 5V and GND and separate data returns) so I can run two cables to monitor all my overhead.