no pinout. No screen printing. There is no answer to my question. Yes, I watched TheSignalPath's video. The case of his device was connected to a ground pin. None of the pins on my device are connected to the case. I've found two different references to this module on the internet and each one has the power and ground pins reversed. I didn't have to desolder and take apart the cover to figure out how to connect it. Is it really that difficult to place the pinout on a screen print or on a piece of paper?
Bundle: Bracket 3 Cup Set & 6 FT Power Cord for Beltronics & Escort Radar Detectors (Accessory Bundle)
34 Review
SilverStone F1 Monaco S radar detector
82 Review
Compact USB-Powered Desk Fan With Four Speeds, Strong Airflow, And Quiet Operation - 310ยฐ Adjustable, Portable Mini Fan For Home, Office, And Bedroom (Navy Blue)
35 Review
Waterproof Hard Laptop Sleeve Case For MacBook Pro M1 14-Inch 2021, MacBook Air M2 13.3'' 2022-2018, MacBook Pro M2 13'' 2022-2016, Dell XPS 13, Surface, HP, Acer - Cloudy Marble Design By FINPAC
39 Review
๐ง FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
๐ฉ๏ธ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review
ASA HS-1 Aviation Headset: Elevating Communication and Safety in the Skies
8 Review
โ๏ธ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review