Review on Inkbird Thermometer Shockproof Splash Proof Protective by Andy Mitts

So I took a chance and this pouch FITS the InkBird IHT-1S thermometer and it fits perfectly in both length and width like it was actually made for him , although it is actually listed for him OTHER thermometer models. BUT there is one drawback, the case is a bit small due to the small external dimensions of 0.98 inches in "HEIGHT". PS (All IMPORTANT internal dimensions are NOT LISTED on Revain). So the InkBird IHT-1S is about 0.75 or 3/4 inch thick so it fits BUT if you use the accessory mesh in the top cover to store the tiny short charging cable that came with the IHT-1S it will the cover inflated upwards and rub the IHT-1S thermometer on that end. So what I did to keep it from bloating and chafing was carefully wrap the charger around. Circle the width of the mesh as little as possible to keep it as FLAT as possible and make sure the 2 sharp metal ends go into the mesh first so they stay on the leftmost edge or bottom of the mesh. To prevent them from scratching or rubbing the thermometer or its screen in any way through the mesh, I also placed a thinly folded instruction sheet between the charging cable and the mesh for added protection from damage. up, but hardly. On the plus side, I'll probably rarely (if ever) use the included charging cable, rather than using my many other USB-C charging cables lying around my house, but it's there just in case I need it. The only problem is that I want to be able to put other things in it. also a storage net, e.g. B. Thick alcohol wipes that I use to clean the sensor after use. InkBird really NEEDS to do a little HIGH BODY to solve this problem. Keep all length and width dimensions the same EXCEPT THE HEIGHT and maybe add 0.25 or 1/4 inch in case height to ensure proper storage of thermometer accessories without worrying about damaging the thermometer too ironically you're trying to protect the case in the first place, lol. Overall I still give it 5 stars because they list the thermometer models they were actually designed for, so it's obviously not their fault that it's a bit small for the new IHT-1S and its accessories. But in my opinion they should have released a PROPER READY CASE when the IHT-1S was released because unlike OTHER MODELS they sell, this model DOES NOT have built in magnets for use on metal surfaces as an extra storage option like their OTHERS MODELS, so either hang it on a hook or leave it in a LARGE (drawer-unfriendly) box. Or you can just toss it unprotected in a drawer and let what was inside blow your mind out. lol. But in conclusion, as far as the quality of the product is concerned, I give it a full 5 stars!