Review on π§ UCTRONICS Raspberry Pi Rack 1U - 19-inch Rackmount Supporting 1-4 Units, Compatible with all Raspberry Pi B/B+ Models by Mike Davis
Expensive and doesn't cover holes completely
These little blank panels are quite expensive for what they are but I wouldn't mind if they did a good job. They don't form a completely airtight seal and due to the way the flex is done they allow a lot of air past the liners. Normally this wouldn't be a huge problem, but a rack that will soon be outfitted with gaskets and filters for use in dirty environments requires a little extra work with tape that could have been used for a lot less in the first place!
- This is amazing
- Not bad
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
Another interesting products
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review