Review on 🔧 Highly Durable Elongation Prototype 3DMaterials by James Broome

I tried this resin on two different 3D printers: Anycubic Photon and Nova2 Mono. Both needed a few tweaks, but no more than any other third-party resin. Once dialed in, the results are really sharp. I made the 28mm miniatures and all the details are just as sharp as regular resin. So far, so good. The big plus is that these things are amazingly strong. I stepped on one and it didn't break. I tried leaving it on the edge of my gaming table when I put the heavy topper back on and not only did it not break, it held up part of the table. This stuff is amazing! It's of little use to me other than thumbnails which I can't accidentally ruin, but if you need strong prints for some reason this will work!