Review on LG EBR74632601 Assembly by Greg Boulden

failed. After I managed to connect all the connectors, the board worked fine, but you have to be careful. If you are replacing any of the above mentioned boards, there are a few tricks to keep in mind: First, the jumpers between the two boards are labeled differently, follow the green board where the black wire is. should go, do not try to match the jumper numbers from the old board. Secondly, in addition to the very flat ribbon cables that have special connectors, there is a cable set. I had to shave off the plastic on these connectors and rotate them 180° to get them to fit in there properly. Pay attention to which pin is the first pin. I recommend taking a picture of your old board while it's plugged in before doing anything with the new board. There may be replacement cables that you can obtain with the correct connectors. Other than that, this was the only issue I had when replacing the old circuit board.