Review on 🔧 UREMCO 1-8 Fuel Injector Seal Kit - Enhanced SEO, 1 Pack by Christopher Kumar

I needed to overhaul the fuel injector on my 99 F150 (5.4L). They are suitable for Bosch EV1 injectors; sorry it's not listed anywhere. I even bothered to email UREMCO to request more details on their various kits and how to install them - cross references, general instructions or whatever. I got a reply (quite quickly and actually over the weekend) but the reply said to just have Revain Vehicle Fitment check my car. Anyway, I got this set to try one before buying more for another. cars I'm supposed to service. It was a good quality set, as good as any other set I've seen. This is the first time baskets have been available and the reason for purchasing this kit. These panniers are slightly shorter than the series FI. However, they entered normally and did not negatively affect consumption. Baskets were crushed with sufficient force. However, it is difficult to understand without manuals, documentation, etc. The needle cover and spacer material appeared to be identical to the original. The attacks felt the same way. O-rings appear to be made of Vitreon; The OEM was a different color and may or may not have been Vitreon, but I would use Vitreon as a replacement any day. Advice only. If you put on the needle cap and feel a slight click but there is still some room, the cap is not fully on. Click again. Use the flesh of your palm and press a little harder. You should feel a firmer click as it goes the rest of the way. Then there should only be a small gap between the cap and the O-rings. You'll get used to double clicking when you click on it. It would be very bad to lose the inlet cap!