Review on 🖨 TINMORRY 1.75mm Filament for 3D Printing by Darrin Parasson

I usually heat a little above the recommended temperature range of 180-200, but I've tried 200 and the results have been quite satisfactory. Good bed adhesion, layer adhesion seems good but there was a bit of tension although it's more like a spider web. I was working on a project with a deadline so I just shelved it without making any adjustments. Layer height, layer width 0.66, speed 70 mm/sec, layer 55, nozzle 200 on a slightly modified Anycubic Chiron. This material printed well enough that I ordered 2 more rolls. Cheaper than the CF PLA I printed with and not likely to break nozzles.