Review on 🔧 NEIKO 03044A 1/4-Inch Drive Mini Ratcheting Screwdriver and Bit Set: Compact Low Profile 8-Piece Set with 90 Degree Right Angle Offset for Close Quarter Work - Phillips, Slotted, and Torx Star Included by Jason Arkin

I tend to keep writing reviews so I'll try to do it quickly. sandblasting. The beats feel more solid than I would expect from such a cheap tool. Handle: These are two pieces of perforated sheet metal painted black. The sides are made of plastic. No sharp edges or burrs. Metal plates are held in place with rivets at the end and pawl, which serve as an axle. Ratchet: The pawl is made of stamped sheet metal with a rough chrome finish. The spring and stopper for the dog are in the handle itself. Directional selection is simple, smooth and positive. The bit holder and ratchet appear to be cast and plated. Gear teeth have no burrs or rounded edges. The racquet is not held in place by magnetism as I read in the answer to the question, but rather by a small coil wrapped around the racquet, the end of which serves as a rough mount. It's all on the side and only visible through a small gap between the ratchet and the faceplate. There is a flange at the back so that the bit does not push through completely. Overall very well made for the purpose and price. Yes, you could smooth out the perforated edges, but since it has nothing to do with performance, you can omit it for cost reasons. All in all a great tool for my pocket or like me and a small tool bag for my desk in the office. would recommend.