Review on Flowmaster 15902 3-4 Piece Universal T-Pipe Kit by Danny Nedumaran

Good kit. There are loads of extra pipes - way more than you need to clear the back of almost anything. The splices are a nice slip fit so you have room to play if you accidentally cut an inch more than intended or something, and lap splices are easier to weld in my opinion. The curves are nice and overall this is the level of quality you would expect from a Flowmaster. All the pieces have slightly different angles so it's easy to see where they go. You bring the muffler up to the trailing edge over the rear end, straighten it again, and rotate the sides out about 45 degrees. If you want to come out straight from the back, just cut a corner off the 45th piece or add your own straight pipe (depending on how far you need to go). On most vehicles, including trucks, the bumper will pass through the supplied tube and stainless steel tab of reasonable length. You'll likely have enough extra pipe left over to cut the other pieces so you can collect enough pipe to still get to the back. Expect the box to be beaten up when you receive it, but even UPS has to work hard. damage the exhaust pipes. :) I would definitely use this kit again on another truck (it was installed on an 85 long Chevy platform).