Review on Tecoom Splash Guards Fender Flares by Jeremy Kakaruk

I installed them yesterday and they should look more like the guards shown by "C" flares. There is a very large (and very unnecessary) internal section that doesn't seem to make any sense. I can remove it with a dremel. I also received four clips, four screws and four washers but the two clips were not the same. (They didn't have holes on either side to put a mounting screw, they were actually flat strong clips on either side.) I had to go to the big blue box store, get two of the parts bins (which were shorter) and use them. So I saved some money and they fit really well but I didn't like that extra interior space that sticks out so far from the bed that isn't attached and doesn't seem to be useful at all and the extra travel to get 2 body U- Brackets to buy " for mounting the rear wheels. Fit grade: actually very good, tight fit on the factory small flaps and a good fit. Design grade? confusing, so poor. Afraid it will be filled with ice. Too bad because half of it was unsecured.