Header banner
Revain logoHome Page
Sergey Chodavarapu photo
United Kingdom, Belfast
1 Level
745 Review
48 Karma

Review on Neitra PRO MAX Cabinet Hardware Jig: Accurate Installation Of Any Length Door/Drawer Handles & Knobs With Punch Locator Drill Guide by Sergey Chodavarapu

Revainrating 4 out of 5

This jig is good, could have been great!

This jig is good, not great. It was easy to set up and use. However, the drill bushing leave a lot to be desired. After drilling 40 holes they are already wearing out. They bushings should be made out of hardened steel, which they are not. I looked online, and it doesn’t look like there are replacement bushing’s available either. It’s a shame, I like this jig, just, too bad the bushings aren’t up to the task!

img 1 attached to Neitra PRO MAX Cabinet Hardware Jig: Accurate Installation Of Any Length Door/Drawer Handles & Knobs With Punch Locator Drill Guide review by Sergey Chodavarapu



Pros
  • PRO MAX CABINET HARDWARE JIG: 10X faster installations, accurately installs cabinet knobs and pulls of any length. In addition to the BASIC Model 16 ×10 inch Cabinet Jig, there are 2 extensions with 32 mm hole spacing and 16 inch extened ruler designed for drawer fronts up to 42" wide and hardware up to 38" center to center. And it provides repeatability: if you have done the left door, just flip it over and it’s already easy setup for the right door
Cons
  • Not suitable for use in damp or wet conditions