Review on Geeetech Filament: Enhancing Dimensional Accuracy for Printers by Ryan Marx

My Ender 3 Pro with improved nozzle, extruded. It took me three tries to successfully print with this filament. This is my first experience with wood filament printing so comparison to other brands is misplaced. The line is very brittle in the sense that it can be pulled off the spool very easily. To get this thread to work I had to rewind it onto a smaller spool I had on hand. I had 2 bad coil prints that broke overnight so I took matters into my own hands. It would be much better if it was half or quarter spool. The temperature should be below the temperature I normally print at. I did it with a 193c nozzle and a print speed of 70mm. Type quietly and slowly.