Review on π§ Kerick Valve M252 Float Mount: Efficient Solution for Float Control Systems by David Herrera
Works great if you already have a potable reverse osmosis system
I installed this on my reverse osmosis system yesterday. A drill between 3/8" and 1/2" was required, but since I didn't have one, I just made a few extra passes on my 3/8" container to make it fit. I have it installed by hand and hooked up to my kitchen to drink a reverse osmosis system and it worked great it took about 10 hours for the container to fill up and it shut down as intended I forgot about it and actually left it on while I was out of the house and half the house came expecting a flooded kitchen no problems so far I will update the review if necessary =UTF8&psc=1
- Hydraulics, Pneumatics & Plumbing
- Something Else
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
