Header banner
Revain logoHome Page
Rick Ross photo
1 Level
1339 Review
67 Karma

Review on MAGBIT 624 4616 MAG624 8 Inch Holesaw by Rick Ross

Revainrating 1 out of 5

Do not use this hole saw if cutting metal

This 2 7/8 hole saw was used to drill ONE hole in a sheet of stainless steel (beer keg) with cutting edges for oil . Before the hole was complete, the teeth of the crown disappeared and became jagged. Compare that to the used 2-1/2" Milwaukee Bi-Metal Hole Saw in my toolbox that cuts two holes in the same barrel with ease. Problems and no visible impact on the hole saw. The Milwaukee saw has been in use for the last 15 years used many times.

Pros
  • Cuts 2" x 4" in one pass
Cons
  • Disappears