Review on 🛠️ AB Tools M10 x 1.25mm Thread Repair Kit/Helicoil Set - 9pc for Damaged Threads (AN019) by Aaron Carney

I've installed many spiral coils over the years and these are far from the worst. At the same time, the crane really needs a longer rope. My photo shows it (right) versus a standard plug faucet (left). The included tap is a semi-low tap and is very difficult to drive into a hole, even with the right wrench, thread oil and lots of threading experience. This made the faucet wobble, enlarging the hole. The finished product felt "soft" compared to the unpeeled holes when tightened to just 43 ft-lb, and I actually let them shy a little for fear they might rip the coiled coils. Not sure if it was just mild stainless steel or if the hole was too big due to the faucet wobbling. It would be 4 stars if the faucet was a properly grounded plug faucet with 4-5 threads to make it easier/straighter to start.