Review on 🔥 TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern by Jacob Jefferson

I recently installed an OEM TRD lift kit but did not want to use the included 1" rear lift blocks. I wanted a 2 inch raise in the rear so I went with this Torch AAL kit. It was easy to install, although I mismeasured and cut one of the leaf pin studs too short; but at least Torch gives you a second set of pins with a slightly smaller diameter. I used one of these with a washer on top which allowed me to complete the AAL installation. I may replace it in the future, although this works for me for now. U-bracket; Once stretched and retightened, it provides all the tensioning force needed for the leaf springs. I easily increased the rear height of my 2018 Tacoma Off Road by 2 inches with no other issues. Make sure you have secure C-Clamps to compress your OEM wing pack after adding this extra tab from Torch. I bent two 8" Harbor Freight C-Clamps, but replaced them with two new ones. I'm sure I'll bend them again, but Harbor Freight gives them a lifetime guarantee :-)