Header banner
Revain logoHome Page
๐Ÿ”ฅ torch 1.5"-2" rear add a leaf lift kit for toyota tacoma 1995-2022 2wd 4wd trd sr5 - 6 lug wheel bolt pattern logo

๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern Review

3

ยท

Very good

Revainrating 4 out of 5ย ย 
Ratingย 
4.0
๐Ÿ”ง Replacement Parts: Shocks, Struts & Suspension, ๐Ÿ› ๏ธ Replacement Parts

View on AmazonView on ะฏM

Media

(4)
img 1 attached to ๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern
img 2 attached to ๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern
img 3 attached to ๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern
img 4 attached to ๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern

Details

BrandTORCH Off Road
PositionRear
Cover IncludedLeaf Springs, Extended U-Bolts, and Hardware
Maximum Lifting Height2 Inches

Description of ๐Ÿ”ฅ TORCH 1.5"-2" Rear Add A Leaf Lift Kit for Toyota Tacoma 1995-2022 2WD 4WD TRD SR5 - 6 Lug Wheel Bolt Pattern

FITS: 1995.5-2022 Toyota Tacoma 2WD 4WD TRD SR5 (6 LUG MODELS ONLY - will NOT fit 5 lug models). CONTENTS: 2PC Add a Leafs, Extended Alignment Pins, Isolator Pads, 4x Square U-Bolts (measurements are from inside the bend 8.5" long and 2.5" wide). INSTALLATION: Bolt on kit. Comes with step by step instructions for the DIY backyard mechanic. Ships Same/Next Business Day. 2-3 Day Delivery. Lifetime Warranty. Dedicated Customer Service. Call or message us with any questions!. NOTES: Leaf springs will provide about 1.5"-2" of lift depending on leaf pack condition. ***WILL NOT FIT 5 LUG MODELS***.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Wanted to return

I bought this AAL to replace the 1" block that came with the OEM TRD lift for my Tacoma as I loved the ride the block gave me and the fact that my leaf pack was almost straight, absolutely hated. The local shop did the install and after 100 miles I've tightened everything up. The ride quality is much better for me, still sitting about 1.5 inches back. I can tell when I charge up my RTT that the rear end no longer sags like used to .I have no squeaks. when driving over bumps (we added some lubeโ€ฆ

Pros
  • Same/next working day delivery. Delivery 2-3 days. Lifetime Guarantee. Dedicated customer support. Call us or email us with any questions!
Cons
  • Long Wait

Revainrating 2 out of 5

First Generation Tacoma - Perfect 2 " Lifter

Very happy with the Torch Add-A-Leaf Kit It let me raise the back end exactly 2". Will probably level out to 1.5" over time. It was pretty easy to install but there is one Few things to watch out for 1. Use 2 heavy duty c-clamps from start to finish Squeeze these wings together before dropping the axle and leaving it clamped until you're done as the Move center holes toward you if you remove the clamps too soon and you never get the center screw. a time when you can't lower the axle far enoughโ€ฆ

Pros
  • CONTENTS: 2 pcs extra grommets, extended dowel pins, insulating spacers, 4 square U-bolts (measured from the inside of the 8.5" long x 2.5" wide bend)
Cons
  • Secret

Revainrating 5 out of 5

Good AAL for Tacoma

I recently installed an OEM TRD lift kit but did not want to use the included 1" rear lift blocks. I wanted a 2 inch raise in the rear so I went with this Torch AAL kit. It was easy to install, although I mismeasured and cut one of the leaf pin studs too short; but at least Torch gives you a second set of pins with a slightly smaller diameter. I used one of these with a washer on top which allowed me to complete the AAL installation. I may replace it in the future, although this works for meโ€ฆ

Pros
  • INSTALLATION: Screw Kit. Comes with step-by-step instructions for DIY backyard mechanics.
Cons
  • No mold required