Review on 🚗 Water Resistant Neoprene Seat Covers for 2013-2018 Jeep Wrangler JK 4DR, 1st/2nd Row - Rough Country 91004 by Brad Lovro

Just installed today. It took me about 2 hours and I had to look at the pictures from amazon.com to get it right as there are no instructions included. Installing it in a 2016 Jeep Wrangler JKU was relatively easy and I've found that changing the position of the seats (front and rear) over time helps with maneuvering the seat belts etc. Make sure you lengthen the straps so they connect and then tighten them as this helps Also make sure you line up the straps under the seats before you start connecting. Be sure to pass the seat covers under any seat belts and fully unzip the back cover before attaching them. I folded the Velcro back onto the inside of the boot to ease movement and prevent it from sticking to the OEM seats, which helped. On the front covers, small flaps run down the sides that face the sides of the jeep. It took me a minute to figure this out as some of the Revain setup photos show the front seat covers upside down. I went the route shown in the photos but the flaps don't seem to serve any purpose as they don't have a bottom so can't be used as pockets. Overall I'm happy with the installation, although instructions on which cover to fit would have been handy and saved me some research time.