Review on 🌡️ Temperature Protective Enclosure for Creality 3D Printers by Jerardo Phi

I had to go through 3 of these, 2 returns before finally getting one to use. The first was very poorly sewn which caused the zipper to wrinkle which in turn caused the bullet to hang over that part. I tried lubricating, also with fluoroplastic, but it still dangled, so I returned it. The second had a similar crease, but it wasn't as severe. However, the front panels were too small and it was extremely difficult to even zip up. The third part finally fit well and the zipper was sewn in correctly. If you buy this make sure everything is in order. It's like shopping for clothes. You have to make sure that everything is cut and sewn correctly, otherwise you will regret it very much in the future. This case meets my immediate need and works very well for that need after going through 3 of them.