Review on Ultimate Precision: MICRO JIG ZEROPLAY Miter Bar for Perfect Miter Cuts by Ghostnote Hankins

I followed the instructions and first adjusted them to fit the slots on my 3/4 x 3/8 portable table saw. The next step, however, was to drill through the top of the sled and attach it to the top using the small screws provided. If these sliders need to be adjusted in the future and are glued to the underside of the slide, they don't seem to be readjustable. I prefer a clean and undamaged surface of the sled. I will be looking for a laterally adjustable aluminum angle bar (spring loaded ball bearings or eccentric washers etc.) that will not require adjustment once it is attached to the underside of the slide from below.