Review on NEEWER® Titanium Nitride Driver Wrench by James Jones

These tools are good for first time use or limited general use, but downtime/ Downtime, patience, and hardware to remove (tedious/time-consuming) if or more if the drivers' tips are used a little, again rounding out the headache over stripped hardware as well as enough of the tools themselves. For me either 1.5 2 2.5mm needs to be replaced with well made / very reliable hex screwdrivers. I say this for my rc "go bagc" that I grab when I head to a party in a frenzy before my wife gets home and find I have a much more frustrating list of tasks to complete . I had several sets so I could have a new set in different places and although I took the time to put thread lock on the grub screws that keep the shaft from turning you really can at this price point can't beat it, especially when you find that you often run out of tools like me, or you just can't afford better tools. Of course I wasn't expecting much and will actually buy myself another set or a similar set, so keep them handy, but if you are new to hobby rc cars or can't afford to buy high end tools then just consider buying a second set, better quality shafts with the same diameter, or just buy the individual MIP drivers you use most often because I have rarely used 3.0mm or the smallest 1.0mm in kit.