Review on 🌟 Enhance Your 3D Prints with HATCHBOX Silk PLA Filament by Kenneth Barnes

This is a review of the filament Hatchbox Pink. Other Hatchbox products are great, but this one sucks. I may have a bad roll but it doesn't print well. Everything goes well for a while, then the shifts separate. 3D Benchy does not print. The hull of the small boat was printed a little, but the top part just fell apart when printed. I thought something was wrong with my printer so I downloaded Hatchbox Yellow and it printed beautifully with no blemishes. If you observe the print of the first layer, it prints normally, and then the flow changes to absent/ripple, and then back to smooth, and then absent. When the next layer was applied, the slightly rippled areas caused the printer to start to really degrade.