Review on RUST-OLEUM 320202 320202 Gallon Clear Gloss 🌟 Coating - High-Quality 1 Gallon (Pack of 1) by Wade Meeks

So I bought this at one of the big hardware stores (buy a second gallon here at Revain), I built a small patio in the backyard of my house (approx. +/- 150 sq ft) To improve the look of the floor I'm a little disappointed with the top coat of Rush-Oleum I did the following: and Cleanerc) Power Wash Again to clean and wash off the product bd) Two days wait for drying) Apply Behr 1 gal. Concrete and Masonry Primer 880.f) Wait 24 hours.g) Apply 2 coats (24 hour intervals) BEHR 1 gal. 1-component tan epoxy paint with satin finish for interior and exterior concrete and garage floors, rust Apply oleum flakes to the last layer. Clear coat for concrete and floors (mixed with 1 sachet anti-rust and oleum anti-slip) The end result looks good BUT I found 2 problems or remarks: A) The finish is not shiny at all (remember this is after 3 coats ) The end results are more like a SATIN finish (I really wanted a glossy finish). B) The one gallon I buy doesn't cover nearly the 250 square feet that the factory claims. Mine was +/- 150 square feet. one gallon of Rust - Oleum topcoat at 100% application of 3 coats to this area (150^2ft). So far the products are holding up well, but as I said, my biggest gripe is the finish (satin, not glossy as the factory claims) and the finish. can I recommend this product? I will say YES if you are looking for a satin finish or know you are going to have a satin finish and 1 gallon +/- 150 sq ft and not 250 as it claims be prepared to apply 3 coats (at least 2 ). I hope this helps someone.