Review on 🔝 Top-rated Spice Sport Bar Covers for CJ5, CJ7, and Wrangler (1980-2016) - Bestop 8000937 by Eric Hartman

First, I'd like to thank the Jurassic Park Jeep guy for suggesting using duct tape. Didn't really read the instructions. The instructions said to lay the fabric with the zippers open, place the foam sheets in, align, peel off the 3M tape backing and tape in place. Since I didn't have any masking tape, I used blue masking tape. I simply placed the foam sheets around the outer arches, except for the two on top of the spacers, since those foam pieces were already attached to the fabric. It wasn't difficult to determine which part went where. I then wrapped duct tape over and over like a barbershop pole before putting the cloth on. The zipper was relatively easy to close after a slight pull. I found that the arches actually have layers on each section of the leg. So you start with the top section, zip up from top to bottom, then the new zip section zips up that zip until you get to where the roll bar attaches to the frame. My universal LED pendant light required making a few small holes with a leather punch behind the seams and a zip tie to reattach.