Review on Arduino Nano V3.0 (CH340) board module based on ATmega168 microcontroller compatible with Arduino. Connector soldered by Micha Kobiaka ᠌

I am new to arduino like controllers. And without dancing, I couldn’t launch it the first time. But if I take the following steps, then I came to success: 1. Connect it via USB to the port that you will later use as the main one. (Pwr will light up on the card and the L-LED will flash.) 2. Download and install the CH341 driver (links in the wagon search engine). 3. Reboot your computer. 4. In the Device Manager, the USB-SERIAL CH340(COMx) device MUST appear in the Ports section, note the x number. 4. I hope you already have ArduinoIDE installed, run it and: - under tools >board select arduino nano. - in the tools>port section, select the com with your x. - under tools>processor select ATmega168. That's it - you can upload sketches.