Review on Upgrade your Jeep Wrangler with Voswitch Overhead Control Panel 🚙 and Source Box: 8-Switch Pod with Blue Backlight for JK JKU 2007-2018 by Sean House

Excellent build quality. Easy installation with quality straps, zippers and panel covers. All inclusive. BE CAREFUL as each circuit has a 30A fuse. If you are using a device that requires LESS than a 30A fuse. either replace in the POD or add a smaller fuse built into the device. I will also eventually replace the 100 amp fuse with a 100 amp circuit breaker. It's easy to reset and power off the POD and work with electrical accessories rather than unscrewing the built in fuse holder, perhaps off the beaten track. Not having a working 100 amp backup fuse is even worse. But then let's be honest. if you have blown a 100 amp fuse or circuit breaker. You either have serious problems or you are doing something very, very wrong. Some good youtube videos on installation and mods to change the device to ignition only. Look for the Voswitch 8 in Bubba's garage. just fast forward all the BS babble that has no value and watch 3 minutes of the associated video. If you want to install POD . You can also buy an expandable 8 switch pack instead of throwing away and replacing a 4 or 6 switch pack. Likewise. Great features: 1) memory dimmer and 2) low voltage cut off at 11 volt threshold. Other devices have a voltmeter. You don't need it unless you need to manually control the alternator or battery output voltage to avoid dropouts. This device shuts down below 11 volts. So you don't have to waste space on a big, bright disk looking for a voltmeter. The device attaches like a rock with the included Lakaien loop clip. I wish all my Jeep purchases were of the same quality and value.