🏎️ B&M 80681 Z-Gate Automatic Shifter: Sleek Black Design for Effortless Shifting Review

Excellent switch. The only problem is that the black console is not designed to mount the switch flush with the floor. The instructions say to trim it to the ground, no big deal just I installed it on the transmission tunnel and it's flat on my truck. I used 3/4 inch spacers to fill this gap, not cut.

Простая установка, работает хорошо, недорого, руководство по установке не самое лучшее, ссылки на "Рис.1" 4 или 5 раз, а "Рис.1" No . I had to call B&M, they said I had everything they needed to provide but after a bet they finally found "Fig. 1” and sent it to me.

Quality is better than the price. F350 '92 with C-6. Full ratchet switches can be a nuisance in the woods. Using a slightly different, slower technique, this switch works without blocking. If you switch quickly, it prevents skipping. I didn't like that I could accidentally go into neutral, so I shortened the linkage (3rd shows neutral, 2nd shows 3rd, etc.). You must pull up the "T" to go into Neutral, Reverse, Park. I wouldn't install this in a specific race car, but would definitely upgrade a…

I have installed them on many hot rods over 30 years. Th350s on Camaros and Chevelles are easier to install than Mopar 904s with the Duster 318 header. Those made today are of poorer quality than they were over 25 years ago, but they come with almost everything you need for installation. You may need more time. Screws for the switch body if your bottom is too thin. The instructions are good. They're a little more expensive than what you get, but still better than the Mega series. It should have