🔧 Accusize Chucking Reamer Straight 5500 SF00 – Enhanced Precision for Optimal Machining Results Review

Came in a wooden box but was never opened. We found that once you get your hand in, you have to support the weight of the reamers. The hinge screws are loosened on both sides. I tried tightening the screws only to have them strip the wood from both sides. I bought two sets of reamers and the box isn't worth the money. But the reamers work and look good.

Ideal for everyday use when reaming holes. I use this to finish and clean holes in 3D printed parts and it's perfect. As with all reamers, the original hole size should be close to but smaller than about 0.030 inch. The result is a very, very smooth hole. Used for 3D printed FDM parts with glass fiber reinforced nylon, ABS, carbon fiber ABS. and carbon fiber nylon. No problem. Just don't run it too high as you could cause melting and use it on a drill press to match the hole axis to the part…

BIG disappointment. See photos. While the box itself was well packaged, the inside is a different story. Some of the reamers were loose, two of the wooden blocks were badly glued and fell apart, the large wooden block that holds the reamers is cracked and one of the extremely weak screws that served as the hinge was completely torn out and bent. , so everything can be "smashed up" with sweeps. The holes in the big block are too big for the size of the reamer, so some reamers - ALL the larger…