🔧 ACDelco Professional Fuel Injector Fuel Feed and Return Pipe O-Ring Kit - 217-3365 (Includes 8 O-Rings) Review

Had to do a decoke on my B8 S4 to replace the fuel injector o-rings but didn't want to buy a full set of o-rings/seals because I didn't remove the injectors. They fit and work on my B8 S4.

I did a deco on my B8 S4, the injector o-rings needed replacing but I didn't want to buy a full set of o-rings/gaskets because I didn't remove the injectors. They fit and work on my B8 S4.

They will only fit one side of the fuel injector on a 2001 Saturn SL2. The other side is a smaller I ring. I tried using them. If the injector is installed on the side with the smaller I-ring, it will not go into the inlet.

Normally these kits only come with 4 rings but 4 injectors require 8. The 1994 4 cylinder Ford Ranger 2.3 uses Bosch injectors with one of these O-rings on each end. Some rubber grease will help with installation in the fuel rail and cylinder head. Fits perfectly and doesn't leak! Highly recommended!

My original o-rings were shaped like a tire. They are in the form of a tube, but after 6 months there are no problems. As in the other review, it took some time to get used to the tool. Apologies in advance: place the ring on the tip of the tool and roll it down to the base (big end). Then just place the bottom of the tool on the tip of the injector and keep rolling. That still saves a lot of time. Just another Ford V8