Enhanced Flexibility & Stability with Adjustable Clamp Co 9166 CORNER Review

The item I received was not as shown. The product was also NOT made in the USA as advertised but was made in China and very poor quality! I sent them back as soon as I received them and will look to other suppliers to find the exact clip I need.

I really can't complain about these clips. The only issue I had was with 1 where the clip pin flexed too easily making the clip difficult to rotate. A simple solution to this problem would be to remove the pin and replace it with a steel pin, which is easy to do if you are able and willing to do a bit of fabricating. Despite an issue with 1 of the 4 clamps I have, I would recommend them as a cheap way to clamp square or rectangular stock for projects. I used mine to clamp square tubes together…

Excellent product, sold at a very competitive price with shipping below cost! These clips also look good on my perforated board. They are made of die-cast aluminum, light and efficient. I used them to fasten loose wooden picture frames I bought at the flea market. You can apply a little wood glue like Titebond between the loose joints of the beveled frame, then clamp them on all 4 sides and tighten evenly so they grip. unbalanced glue. The frame will move if you don't use 4 clamps at the same…

Works well but clamps don't adjust well. Screw terminals do not hold well and are off-center. If the clamps are off-center, the bolt will bind when you tighten it and you must be careful not to damage the threads. You have to hammer it in somehow by holding the screwdriver flat with one thumb while holding the board and tightening it with the other hand. Oh yeah, you might need 3 hands. Also, for some reason, there is a 1/8" groove on the inside edge of the flat-bottomed clamp bar. The problem…

I have been looking for cheap angle clamps to help with frame making and other small woodwork. Many of the inexpensive strains got a lot of bad reviews, so I was a little disappointed that I would find something that would suit my needs without breaking the bank. Then I saw them at a local hardware store and they looked to be of acceptable quality. Revain had a good discount on them so I ordered and hoped for the best. They have a more polished look and feel than most budget competitors. For…

I originally got a set of 4 of these clips because my wife wanted to make some frames. It was many years ago. After the frames were made, the clamps were boxed up, stored and forgotten. Still, they looked a little, well, flimsy and below my carpentry standards. The Kreg Pocket Hole device changed that. When making quick boxes and crates, using two of these clips to secure each 90 degree pocket hole connection simplifies construction. Clamp placement requires some practice: look for a mark on…