🚫 AEM 21-732C Cold Air Intake System (Not CARB Approved) Review

Tengo un WRX CVT 2016. The intake manifold has noise insulation and great acceleration before installing the car, which can be used alone depending on how long it is in D, N lasts o P. De repente se le baja las revoluciones hasta que se apaga, lo tove que desinstalar. Not recommendable.

Very good sound when accelerating. Very noticeable sucking noise. It's almost as loud as my Indivia exhaust. Haven't set it up since install so not sure if there are exact wins. It doesn't feel much different, it just sounds really good. Installation was easy and hassle-free with the right tools. Improves the aesthetics of the engine.

Great product. Easy to install by yourself. The bottom bracket does not have to be opened. You can install everything just by opening the hood. You can hear the turbo coil when you step on it and a BOV-like noise (but not a high-pitched noise). You will like it. You don't need a ringtone for this item because I installed it without a ringtone and it worked great.

Installation took about 40 minutes using basic hand tools, all work was done from above, no need to drop the protective cover to unscrew anything. Sounds very good with bumba bpv! Lots of cock! And tutu! My only complaint is that the heat shield doesn't play well with aftermarket charge tubes. All I had to do was adjust the charge tube to leave a 1/2 inch gap between the heat shield and the charge tube. Also when I start my car it rattles metal on metal for a split second, not while driving or…

This is what my car needs. Should have bought it a few months ago. Easy installation and great sound! Allows me to shift much faster at higher revs. The bearing BOV is clearly audible. I'm still trying to see if I can save some more fuel. Unfortunately it won't come to that, because now I want to step on the gas as often as possible. You can clearly hear the air leak and I feel like the car has a little more torque than before. Highly recommended to anyone undecided. I run it without melody. I…

The AEM cold air intake is very well made. I'm not the smartest, but I was able to install everything in about an hour. I recommend using a small ratchet since a lot of unscrewing takes place in hard-to-reach places. My 2018 WRX had an extra frame that isn't shown in the 2015 manual so those with the newer model just know to reach under that frame. Overall, power has improved with more throttle response, and the torque drop in second gear at 4400 rpm is much less. Power really picks up at…