🌬️ Enhanced Airflow 300-574 PowerAid Throttle Body Spacer Review

Dodge 3.7 v6 does not fit. Even though the ad says so. F amazon I am about to order auto parts through you. Thanks for another Amazon headache.

This is the second one I have tried from Airaid. The first one I tried was AA310-618 and now this one, none of them fit Mitsubishi Raider 2006 3.7L V6, don't waste your time and money.

I have used these throttle body spacers on all my cars and trucks. This gasket for the 4.7 liter Dodge engine significantly increased performance and fuel economy. This particular throttle body gasket was for a 4.7 liter engine with a plastic intake manifold so see which you have before you order.

I bought this gasket and installed it on my 2006 Dakota with a 4.7L HO setup, not bad if you're mechanically inclined. Directions could be better and have better photos. I only installed it for 3 days. A little howl under acceleration helped increase throttle response time. Haven't used it long enough to see how it affects fuel economy, only driven 5-6 miles. Combined with the K&N cold air intake and MBRP exhaust it definitely goes a long way in beefing up this engine.

I got the role when they said I would and it was amazing. I installed it the same day, it wasn't difficult at all, just follow the instructions, the only thing I was stuck on was where the throttle cable went because the Dakota 05 has a plastic inlet box and I was looking for a metal nut . plate as indicated. So if you have a Dakota 05, just screw the cable bracket to where you removed the throttle cable. However, once installed, I found instant throttle response, which was amazing. But I have…

I fitted one of these to another car a few years ago so I expected - and got - a nice improvement in throttle response and power, especially in the low rpm range. The kit is easy to assemble and the instructions are good. I encountered two minor issues, both related to the app and therefore unrelated to the quality of the product. Also, I installed this on a vehicle that already had an Airaid air intake, so the small parts that adjusted the position of the stock air filter didn't fit in this…