🔧 Enhanced Performance Airaid 510-502 PowerAid Throttle Body Spacer Review

I have ordered this twice both times with no seal. Ordered elsewhere. Installed and used the old part. Not enough information to install. I had to change and use my imagination. Toyota Tacoma 2000 3.4L

Wow what a price can't beat this price from Revain. This throttle body was installed over the weekend and wow works really well, some sound but then it goes away. Thanks Next is the cold air intake RevainPS K&N

Was on the air when bought. I'm glad I did. The installation took about 30 minutes (at the same time I cleaned the throttle body). If you can handle cars quite easily, if there is no good manual, you can handle them quite well. Doesn't really help with cable bracket placement but easy to figure out. I also had an Airaid intake pipe which I recommend but had to make a small notch on the coupler to get it in place with the throttle body spacer. Otherwise no problem. Noticeable increase in…

I can't get it to work, I have a '99 Tacoma. I bought this with a K&N air intake but when I installed it it barely idled and then when I give it gas it dies and gives a code (I don't have a reader). I followed all the instructions on the T (even after disconnecting the battery). Swapped all vacuum lines (there were better days), cleaned air mass meter, swapped plugs and cables, but still no respect. I called the manufacturer but they couldn't tell me what the problem was. I finally removed the…

I've ordered this twice, both times without a gasket. Ordered elsewhere. Installed and used the old part. Not enough information to install. I had to change and use my imagination. Toyota Tacoma 2000 3.4L

Was up in the air when I bought it. I'm glad I did. The installation took about 30 minutes (at the same time I cleaned the throttle body). If you can handle cars quite easily, if there is no good manual, you can handle them quite well. Doesn't really help with cable bracket placement but easy to figure out. I also had an Airaid intake pipe which I recommend but had to make a small notch on the coupler to get it in place with the throttle body spacer. Otherwise no problem. Noticeable increase in

I can't get it to work, I have a '99 Tacoma. I bought this with a K&N air intake but when I installed it it barely idled and then when I give it gas it dies and gives a code (I don't have a reader). I followed all the instructions on the T (even after disconnecting the battery). Swapped all vacuum lines (there were better days), cleaned air mass meter, swapped plugs and cables, but still no respect. I called the manufacturer but they couldn't tell me what the problem was. I finally removed the…