💡 Alla Lighting 3157 LED Bulbs: Ultra-Bright 3156 3056 3057 4157 3457 4057 LED Brake Stop, Back-up Reverse, Turn Signal Lights, DRL, Taillights - 6K Xenon White Review

We hoped that by buying LED bulbs we would never have to change taillights again. It wasn't like we found out when we were pulled over last week because we only had one working taillight and the brake lights weren't working. When I checked the headlights, a bulb fell out of the socket and about 1/3 of the LEDs on the sides burned out (they never snapped into the socket). Another bulb remained in the socket but more LEDs burned out including the entire top row on the sides and all 3 on top…

I tried 3 different sets of LED headlights on my 1997 Dodge Ram. The price ranges from $90 to $37 (lowest cost). Of the 3 I tried, only these gave the correct beam and pattern. With LED headlights, it can be difficult to figure out the best position to place them in to get the right beam pattern. I almost gave up trying to find the ones that would work. By the time I installed this set I had already decided that if they didn't work I would try something other than LEDs. But I was pleasantly…

Fits great and works great even with stock halogen taillights. Very bright and enhances the appearance of the light itself. I like how LEDs turn on and off compared to halogen lights. One downside is that you will most likely need a pull-up resistor to prevent "hyper flash". This is perfectly normal and your headlights are working properly. This only happens because LED bulbs use less electricity than halogen bulbs and therefore your car thinks the lights are off. Install resistors on live…

Headlight upgrade on my 2005 GMC Sierra truck. Looks great. Parking lights and reversing lights in the Champion. For example, reduce the power consumption so that the lamps do not heat up. However, on my truck, the turn signals light up very quickly when plugged into the turn signal socket. This is because LEDs don't draw as much current. The only solution I've found that doesn't cause other problems is to put resistors on each bulb. As a result, the current drawn moves so that the lighting…

Further upgrade after several months of use. I have come to the conclusion that these lamps are a total waste. The LEDs themselves are fine. Nice and bright. Connectors, on the other hand, are utter nonsense. I've been pulled over twice because these bulbs absolutely refuse to make proper contact in the plug. I can pull out the braid, shake the lightbulb and watch it go on and off. The standard bulbs I reinstalled don't have this problem. I wouldn't advise anyone to buy these as they pose a…