🔩 Amana 55264 Quick Countersink Diameter Review

I have used many different countersinks over the years and Amana has always been the best by far. The two carbide blades cut cleanly through every material I've used them on: hardwoods like maple and oak, softwoods, melamine and more. If you drill a lot of pilot holes, this is the BEST drill bit. The cutter version also works great in a drill press.

Recommended for finishing leaves a clean hole with sharp edges Have had this for a long time but unfortunately only used it a couple of times as it was expensive and how spicy it was. I countersink almost every screw I install, when I say countersink I pre-drill with a countersink, but that doesn't mean that I always use the same part. It just means I pre-drill everything!

1st is my 2nd washer tool. The first one worked really well until I ran into a braid nail (a carabiner cutter broke off, don't know why it happened but it did). I decided it was my fault, no problem. So the holes weren't that clean after using the chips so I ordered a second one. 3 holes were cut in the soft jaw, the drill broke and the carbide cutter broke. 3 holes in soft pine!. Not to mention the picture has to end with a hex head for my drill's quick coupler. Totally disappointed and will…