Header banner
Revain logoHome Page
anchor 3182 torque strut mount logo

Anchor 3182 Torque Strut Mount Review

4

·

Excellent

Revainrating 5 out of 5  
Rating 
5.0
🚀 Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to Anchor 3182 Torque Strut Mount
img 2 attached to Anchor 3182 Torque Strut Mount
img 3 attached to Anchor 3182 Torque Strut Mount
img 4 attached to Anchor 3182 Torque Strut Mount

Description of Anchor 3182 Torque Strut Mount

made in china. package dimensions : 7.9 l x 3.2 h x 7.4 w (inches). package weight : 2.82 pounds. Fit type: Vehicle Specific.

Reviews

Global ratings 4
  • 5
    4
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

I followed Laura Cullen's review and.

I followed Laura Cullen's review of July 5, 2015. I just made a relief cut on the new anchor and used a C-clamp to indent it slightly. This DYI project only took me less than an hour and saved me $600.

Pros
  • Torque Racks
Cons
  • Not bad

Revainrating 5 out of 5

No questions. for engine parts

Replaced strut bushing on a 2005 Ford Freestyle. Do yourself a favor and freeze it for 24 hours before attempting the install. I'm wearing it, but I hope I never have to do something like this without abs again. I saved a hundred dollars by buying the entire strut assembly and lowering the motor for the install. But with a hammer and 2x4 it took a lot of work to get the bushing in place.

Pros
  • Automotive
Cons
  • Unsafe

Revainrating 5 out of 5

DIY repair saved me $675.

I purchased this part to replace a roller drag bearing (engine mount) in the drivetrain that had rotted on my 2005 Ford Freestyle FWD. First I had to cut out the old metal edge (this part took about an hour). I then used the same hacksaw to cut twice through the metal at the top of the new anchor piece so the piece of metal went straight into the bracket.

Pros
  • Engines and Engine Parts
Cons
  • weak

Revainrating 5 out of 5

Remove the control handle and use the press!

5 stars for this product because it is exactly as advertised and OE quality. to a local small auto or mechanics shop (or if you have a press and the right size sleeves/collar you can make them yourself). You should be able to press out the old one and press in the new one in less than 5 minutes after assembling all their tools/sleeves/sleeves. Мне потребовалось около 40 минут, чтобы вытащить старую, и около 3,5 часов, чтобы прикрутить эту новую деталь и запрессовать ее с помощью самодельных…

Pros
  • Engine Parts
Cons
  • So far so good