🔌 Anderson Metals Female Fitting Coupler Review

Not much to say about this, but well made, no burrs or flaws. I've used it to connect an air tool and while the threads on either side aren't very deep I just used some teflon tape to seal and did what would otherwise be done with a rubber o-ring or washer. Would buy again if needed. However, this is for life.

I purchased a propane quick coupler hose and then found that I can't connect to the LPG generator through the fifth wheel quick coupler outlet. I was able to establish a connection via this double socket connection. I removed the safety quick disconnect valve, installed the coupler and attached a 1/4 inch quick disconnect which I inserted into the generator safety port valve. Difficult to find at Revain and local hardware stores don't know about LP's quick connect.

I was confused installing a water hammer. The surge arrester was marked "1/4" OD, but its male terminals were 1/4" ID (ID). I couldn't figure out why this female 1/4" ID sleeve was sliding on covered terminals. The male connectors were .43 inches and this female pair is .455 inches. After searching the internet for too long, I put on a mask and headed to Home Depot. The plumber told me that the water hammer absorber has a compression fitting. I went home and found a YouTube video explaining how