Antec Performance P82 Flow ATX Mid-Tower Case: Tool-Free 🖥️ Tempered Glass, Removable SSD Rack, White LED, 4x 140mm Fans Review

When I started working on this chassis to house my system I noticed a few things that could/should be improved : 1. The noise insulation on the side walls is made of foam. I recently built a couple of systems around a P5 chassis that uses fiber padding and thought it would be the same. There is no such happiness. This is where foam comes into play. What's the problem with foam? Over time, the foam crumbles. When heated, decomposition accelerates. I absolutely do not expect this foam to turn…

Really Quiet. Airflow isn't great for the number of fans, but that's to be expected. The space is quite generous. For some reason it has a slot for a CD drive. I currently have 7 hard drive slots occupied and had no problems. The hot-swap cages are a little suspect, as you have to flex them a little more than I find comfortable to attach the rear pins. Hard disks in the airflow path are actually very important when you use them. somewhat consistent that with RAID or softraid (like md or zfs…

This is a good case, it has some flaws compared to the Creeper but is still open and handy for easy adjustments. If I had known the following things in my planning I could have spent more on Liana but I agree with the upgrade to make it work but it will cost me a lot more in the long run. 1 I have a long GPU. Therefore there is no space for 360mm radar and fan on the side, see picture. So I could only put him on the ground with the next horse. I have to get an adapter for USB 3.0 as it's…

My biggest gripe with this case is the lack of cable attachment points, there really is no excuse why they shouldn't be there. disk compartments. In order to install three 120mm fans on the side brackets, you need to remove one of the two hard drive bays as there is hardly enough free space. If the slots were reduced by just a few millimeters or the case height was increased, that wouldn't be a problem. What I like is the open bottom at the top of the list. All wall cabinets with windows must…

I bought it because I don't care about the assembly I see that most cases impose aesthetics on you. I also had a price point. The photos here don't do it justice, while they look great, but I'm not going to flood the internet with any PC builds. So from the massive Silverstone ft02 medium tower where everything was tilted 90 degrees and there was just bukku. Room, I had a lot of expectations from moving to something smaller (still the standard mid tower) but the hard drive bays, a 5.25 and a…