Header banner
Revain logoHome Page
πŸ”© apdty 112685 intake manifold bolt & grommet set - brand new, pack of 10 logo

πŸ”© APDTY 112685 Intake Manifold Bolt & Grommet Set - Brand New, Pack of 10 Review

4

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸš€ Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(3)
img 1 attached to πŸ”© APDTY 112685 Intake Manifold Bolt & Grommet Set - Brand New, Pack of 10
img 2 attached to πŸ”© APDTY 112685 Intake Manifold Bolt & Grommet Set - Brand New, Pack of 10
img 3 attached to πŸ”© APDTY 112685 Intake Manifold Bolt & Grommet Set - Brand New, Pack of 10

Description of πŸ”© APDTY 112685 Intake Manifold Bolt & Grommet Set - Brand New, Pack of 10

This Is The Crush Bolt With Built In Rubber Grommets. Properly Seals The Intake Manifold From Vacuum Leaks. Match Vehicle To Compatibility Chart To Ensure Exact Fitment. For Use With Compatible ACDelco 89060413 or See 02-06-04-023A/P0332 For A TSB Kit That Includes Gaskets & Knock Sensors.

Reviews

Global ratings 4
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    1

Type of review

Revainrating 5 out of 5

Perfect for intake manifold and parts

Bolts fit my 2001 Suburban header perfectly. A screw broke while tightening. I would recommend replacing all of the bolts if you need to replace the manifold gaskets.

Pros
  • Weight
Cons
  • Outdated

Revainrating 2 out of 5

Too expensive, there is a better choice.

It's not worth spending $130 on screws. LMC offers quality parts that always fit together perfectly. I was able to get them from LMC part number 30-4248 for $49.95 plus shipping.

Pros
  • 1 year trial
Cons
  • Commercial

Revainrating 1 out of 5

For 10 not everyone you can go to Home Depot and .

$128 was too expensive. For 10 I don't recommend anyone, you can go to Home Depot and get this screw for 2 for $2. Just use your old case that came with the ones you took out, they work just as well, maybe even better.

Pros
  • High marks for support and durability from testers
Cons
  • Hard to tell

Revainrating 5 out of 5

Expensive but correct

These are the correct screws, same as OEM. If the bushings fit a little more into the holes on the stock plastic intake manifold then that's fine, the originals on my 2002 5.3L truck engine did the same. Just twist them at an angle and they go in the hole. I replaced mine because the old bolt heads were rusty and the new ones are applied with thread sealant and ready to go. After installation I cleaned the screw heads with acetone and applied a small brush of urethane anti-rust paint to protect

Pros
  • Inspires confidence
Cons
  • Generally good but...