⚡️ Efficiently Power Your Devices with BBE Supa Charger 8 Output High Performance Power Supply Review

I bought this pup in March 2012 and since then he's powered my pedalboard in so many ways. I almost always had overdrive, noise gate, multiple modulation effects, DigiTech drop, compressor and 12v radio receiver. The Supa charger kept everything going for 6 years. The only quirk I encountered was most likely a quirk of the DigiTech Drop itself. For some reason the Drop doesn't work on any port after port 4. However, all other pedals on it work fine. Disclaimer: I have not tried any other…

My pedalboard originally used a daisy chain wall stud system. Adequate performance, but quite a bit of noise and rumble. My best wife gave me one of these for Christmas. There is no more hissing and humming. The only problem was that one particular pedal, the TC Electronic Nova Repeater, used a little more power than a regular pedal, especially when starting up. I had to use one of the higher powered sections at max voltage to make it work. The default outputs are 100mA and the pedal specs say…

I hope to save others the trouble of ordering this very lame power supply. My wife bought me two of these a few years ago and they have served me well. One of them started to fail so I decided to replace it. Received today, unpacked and checked the outputs with a multimeter. With the switches set to 9V all outputs looked normal except output 7 was 0 volts. I moved the switches to higher settings and output 7 still read 0 volts. But outputs 5 and 6, which should be 16 volts, showed 20 volts. Too