🧵 Beadsmith Thread Zap II Thread Burner 5.25 Inches Push Button Battery Operated (1xAA) Trim Burn Melt Thread One Touch Ideal Finishing Bead Weaving Stringing Projects - Enhanced SEO Review

installed battery and checked everything OK the tip got hot for a few seconds but after 3 bracelets it no longer turns red hot also the transparent plastic cover doesn't stay in place to keep the tip in place during can be damaged during storage unless you tape them in place, which is a bit awkward. I have to admit I expected a better product from Beadsmith. Difference maximum 3 bracelets on 1 battery

They are good for cutting braided beading thread which is difficult to cut with scissors. It is very easy to use and heats up in a few seconds. The problem I have is 1) it doesn't always work. Even if the arrows are lined up, it doesn't always want to turn on. It's usually more secure if I screw the top on tighter (but is it supposed to be that way?) And 2) the safety feature that prevents accidental activation is a loose plastic cap that sits on top of the top protecting the tip and obscuring…

I bought one of these many years ago, it worked for a while when I first got it and then stopped working, but I forgot about it all that time and bought another one somewhere else. The one I just received doesn't have a working button so it's useless. Either way, it's a piece of junk that might work a little at first if you're lucky, but not for long. I also just received a larger version called the Cord from the same company which heated up and turned bright orange for a few seconds and then…

I got this because I've seen a lot of other leather artists using it and wanted to watch it on my YouTube channel (I'll add a link when I post a video ) . Maybe it was just the one I got but I shouldn't have worried. I had a new battery that I took from another device that I just put it in. Didn't work, different battery, still nothing. Check the tip, remove and insert, make sure it is tight and working. Try on a branch and nothing. These things work very simply, the button closes the circuit…

I've been using this thread burner on several bracelets for about a week now without any problems. When you're ready to go, press and hold the large side button and within 3 seconds or less the tip will be red hot and ready to go. When he hits the thread, he immediately cuts through. You can easily get to the very edge of the knot and sing off excess thread with ease, and the finished product looks amazingly clean! So happy with this product! Right after I'm done using, put a cap on it, the top