🔘 Two Chrome Finish Bearing Buddy Protectors (2.047" Diameter) with Two Brass Components Review

They are a perfect match for my Harbor Freight Haul Master 1720lb trailer. Exactly what I needed. Just make sure you have a rubber mallet handy as you really have to hit them for them to seal.

Unlike the fakes sold at Harbor Freight, this product fits 52mm HF trailer hubs. Fits perfectly. Well done. They didn't even leave a mark after being tapped with a hammer.

This is a must have for anyone looking to buy a Harbor Freight trailer. Simply adding lube to the hub becomes even easier with them, especially when needed at any frequency.

Glad to have them but they were difficult to install. The fitting seemed badly milled and had rough edges. I had to write it down carefully before they continued.

I bought a new trailer that was having a hard time getting grease into the wheel. This solved the problem and ensured you could see the grease level by removing the protective caps and looking at the spring loaded grease reservoir. Worth the investment.

First let me say I'm a little disappointed with Napa as they insisted my trailer may have overheated at some point and it's about time the hole was replaced for 2nd gear Customs, covers or bearings unsuitable is needed. At the same time, they went through without any problems and solved my need. As others have pointed out, they are for Harbor, Buymart and other Chinese import trailers.