🔧 Bell & Gossett 118223 1/12HP-1/6HP MOTOR MOUNTS, Black - Sold in Pairs Review

easy install on my BG circulation pump. I found a video on u-tube on how to make it yourself and it was as easy as peeling pears. I also replaced the clutch spring. The pump is now silent.

Direct replacement for my old B&G 100 series circulator pump. Replacement is easy but requires dismantling the motor.

These brackets were just what I needed for my noisy circulator pump. The old motor was noisy and drove through the water pipes. Easy to replace and served its purpose. Fits my fairly old B&G pump # MRF 58 JV

Easy to install and seems very solid. I used them on a B&G 100 series pump in our radiant heating system. It's been about 1 month of the heating season and everything is fine. Much quieter than before. I also changed the clutch.

Exactly and carefully replacing the instructions will ensure that the clutch does not break again. Six months later no problems. Keeping an extra kit ready for another booster pump showing bracket sag.

Motor mounts are perfect for Bell & Gossett 100 series pumps. These are consumable items and for the price I have a spare set of mounts and motor couplers right next to the pump . If they fail, it's a lot cheaper to replace both at the same time in about 20 minutes than paying a tech to come out and replace them for you. Mechanical know-how is minimal and if you search YouTube you can find some good videos that clearly explain and demonstrate how to remove the old ones and install the new ones.

This was original equipment from the manufacturer and was a perfect match for my Bell & Gossett 100 series circulator pump. I recommend watching a video on You Tube to better understand how to remove it as the inner ring sits firmly on the shaft pump. It requires a little dexterity with a heavy hammer. Also, when removing the clutch, the HS-105-SM-R4 Technical Manual states that the clutch must be disengaged before the four bolts securing the motor to the bearing assembly can be removed…