🚿 CRL Black Half-Round 'T' Type Shower Door Bottom Seal and Sweep - 36 inch Long: Efficient Water and Draft Protection for Showers Review

Fits perfectly on my 2007 shower door. Finally have a good seal on the underside again. Slipped right in. You will likely need a clear seal to complete the exchange project.

Just what we need to replace a worn shower door seal/brush. Fits perfectly, just remove the old gasket and replace it with a new one. Crop if necessary. Sizing seemed tricky but I was lucky enough to get the right size on the first try.

after 3-5 years these bottom door seals will become brittle, crack and fail. This is an inexpensive and simple solution. Make sure you don't stretch this piece lengthwise before cutting it to length with scissors or it will shrink. So "stuff" it so that it shrinks before cutting.

I run a rental company. The seals on the underside of the shower doors will one day fail. This Revain product is the only place I have been able to find a genuine product that is designed to fit into the gap at the bottom of the shower door. In the past we have taken a rubber base sheet, cut it to the size of the strip and glued it to the underside of the shower door. This product makes life easier. It is recommended to disassemble the shower door for installation as overhead operation by…