🍾 50 Set Stainless Steel Round DIY Bottle Opener Insert Kit with Screws - Premium Hardware Parts Supply Review

Works as expected but as other reviewers have said throw the screws straight in the trash. They're not made of metal, they're made of cheese. I drilled pilot holes before screwing them in, but the screws still broke.

Disappointed with this bottle opener insert. Their dimensions were as advertised and they work fine with a 1 9/16" bit, but many of them rusted (mostly screws) within 2 weeks of installation, ruining the entire project.

I made some bottle openers out of resin and the screws were too long. I didn't notice and they bumped the back of one of my favorite things. You'll have to find shorter screws or grind them down for the job.

I used to buy more expensive inserts from the national lumber chain. The price was ok so I gave them a try. Well! I even prefer the smaller diameter for bourbon keg openers. Forstner 40 mm is ideal for insertion.

Decent Bottle Openers. I needed something small for what I use them for. With that in mind, they're a bit harder to use, but they work. There are not enough screws in the bag to use all 3 holes. They are strong enough and won't bend when opening bottles. The model is a hexagonal 3D model that I 3D printed, molded and cast in resin.

I like the finish on the brass opener. They look like aged brass and go well with different types of wood. However, the included screws are as fragile as a newly hatched bird. I loosened 2 cap screws in the wood I was working on and pre-drilled the holes.

Just pay a little more for seesaws. These screws are incredibly soft and the heads simply shear off even after pre-drilling. So you have broken screws stuck in your work piece. So I have to decide whether I should find other screws of the right size or just buy better bottle openers. Save yourself the headache and buy a better brand than this.

Worthy newcomers. I needed something small for what I use them for. With that in mind, they're a bit harder to use, but they work. There are not enough screws in the bag to use all 3 holes. They are strong enough and won't bend when opening bottles. The model is a hexagonal 3D model that I 3D printed, molded and cast in resin.

I like the workmanship of the brass opener. Wood. However, the supplied screws are as brittle as a newly hatched bird. I snapped 2 cap screws in the wood I was working on and I pre-drilled the holes. If you throw away the screws with it

Just pay a little more for swinging. These screws are incredibly soft and the heads simply shear off even after pre-drilling. So you have broken screws stuck in your work piece. So I have to decide whether I should find other screws of the right size or just buy better bottle openers. Save yourself the headache and buy a better brand than this.