🔩 Pack of 10 Bottom Shield Fasteners for Ford Focus Engine Undertray Cover Clips Review

Fits my 2013 Ford Fusion. The long screw is good but too tight. Would give 5/5 if the screw was a bit wider. I only bought it for braces as I lost most of it over the winter. When my engine cover came off.

Washer too small for sliding holes. I had to find a larger one of my spares. Also, the hex cap size doesn't match either the metric or imperial tools in my SAE tool kit. And I would recommend them to use the original T30 other than the Hex.

I've read some bad reviews from people saying they don't inhale well. I would suggest just finger tightening while screwing onto the plastic. They fit my 2018 Fusion Hybrid SE very well. I only used 9 out of 10 to hold up the fender, highly recommend.

I had a very different experience than others. The clips went in fine, but the screws wouldn't tighten and I was able to pull them out with my fingers (it definitely wouldn't hold the lid). I had to find various slightly larger screws and washers to make it work.

. Ford Fusion 2016 Ideal for under engine air deflectors. much lower cost and appears to be identical to the Ford factory. These fasteners (like fords) seem to break/pull threads easily (when removed by untrained mechanics lowering or overtightening the bolts). However, I've never broken one. My problem is that the bolts roll on the floor and magically disappear when the engine oil is changed. I repainted bright white so I can find it. . and added wing washers to the bolt heads to better…

Purchased for use on a 2016 Ford Focus SE hatchback. In a past life it was a rental car and the bottom was removed (perhaps for faster service?). I bought a new floor but there were no screws in it. The red plastic clips were still in my car so I haven't used them and can't comment on their quality. The screws work, but the washer is slightly larger than the holes they cover in the compartment. I have a feeling that if one of the holes is only slightly enlarged, or if the screw is…