Bully BC 902 Aluminum Safety Cinch Review

The bone is very light and has a good finish. I didn't have a retainer but the pilot manufacturer was great! Call 800 and bada bing they solved the problem. I will be buying another one for the other end of the tow strap!

Such a cool thing. I'm new to Jeep Wrangler. I just bought my first one and I love it now. I've never heard of this little tool, but now that I have it, I highly recommend it. So easy to use, just hope they stand the test of time. The time will show.

Economic strap for use with tow straps up to 3 inches. I would not use this strap with a 4 inch tow strap. It's not long enough and the ends could be a larger diameter. They are lightweight but durable. Easy to use and I always have two in my tow bag when I go into the woods.

One of the small keyrings was missing from one of the packs - it might have fallen out of the pack (hard plastic to open - the kind small parts tend to fly off when you finally open the pack). I ordered 5 airplane trinkets for $5. One for the missing one and four for the blocks I'm going to build from 1" pipe, welded some washers to the ends and drilled a few holes in the pipes.

This thing is pretty basic. Basically you are creating a clutch with it. You pass the ribbon around the item, then take the standing part of the ribbon, take its loop and thread it through the sewn-on loop at the end of the ribbon. You then tuck this piece between the standing portion and the sewn-on loop, and as you tighten the strap, the bone prevents the standing portion from slipping back through the sewn-on loop, essentially creating a knot. Every boater is familiar with this system and it

I had a chance to use this about 1 week after receiving it so it was fun. I helped a stranded motorist tow his stuck car to a parking lot and at first I played around with it, getting the spring loaded bone right and just making sure it stayed in place. tying any nasty knots or whatever (I only have one of these. On the other end I put the entire tow rope through a loop to hold it in place, but apparently this only works on one end). I could get another one just to make it even easier to…