🔌 Bussmann HHX In-Line MAXI Fuse Holder with Cover - 60A, 32V - #6 Wire Leads, 1 Pack, Black Review

6 AWG wire. Wire AWM Style 3288, 150 degrees Celsius, 600 volts, outside diameter 9/32. The copper wire is untinned and five inches long on either side of the fuse holder. The fuse holder is made in Taiwan. The rubber boot fits snugly and stays attached to the body of the fuse holder. I bought a Bussman 40A Max fuse from Revain. Fuses are made in the USA. Just buy, you will not be disappointed with fuses or fuse holders.

Like all fuse holders that use round quick disconnect plugs they will eventually pop out. The OEM caged spring styles don't have this problem, but other than getting another fuse box from the junkyard I'm not going to fix this in my application, so I just have to bend the rounded metal back down. a little when it starts letting go of the locking wires. OEM flat spring cage connectors also require less insertion force. I can't find a built in fuse holder with this type of plug so it's still…

ok so didn't really use it. I needed an ATO size but had trouble finding a 40Amp fuse holder that size. All ATO sizes I see are rated for 30 amps. Being an electric scooter I figured the next size up would fit. However, the size of the MAXI was huge. It was too big for the battery compartment. I went for a 30A ATO instead and replaced the old 40A fuse with a 30A, the fuse holder is top quality. Wire number 6, which is a bit difficult to bend. The cap is a little tight, but that's usually what…

In general, the goods correspond to the description and arrived in good condition. The only recommended improvement I can suggest concerns the shipping method. Item will be shipped first class with tracking number. A few days after it was shipped, it completely disappeared from the post office's tracking system, except that it arrived late. I had no idea where it was or when it would arrive, and I had to contact the seller to get a rough idea of what time it might be "late". I understand that…

Wow! The thing is huge! The dimensions given did not fit me, but I am satisfied. I bought two for amateur radio. I ran good quality 6ga wire into my cabin, hooked it up to a good fuse panel and needed good quality fuse holders to connect to the battery. I was looking for something better than what you can find in auto parts stores and I found this one. I can manage my setup with confidence and upgrade/add components later without having to go back and upgrade cables or fuse holders. I bought…

I bought this to add an extra power rail to my truck so I can set the timer off feature. It's deceptively large. The fuse section is 3-3/8 inches long. The pins are 5 inches long and really need 1 inch more as the 6AWG cable has limited flexibility. " Mounting hole in the plastic fuse holder. The medium-hard rubber boot has a molded loop mount on the wire and is easily removed from the plastic fuse holder. The fuse holder appears to be glued or welded on, so it cannot be opened to increase the…

Wow! This fuse holder is a beast! The quality of the wires is top notch. all copper wires (AWM is a 150°C rated electrical wiring material with a strong PVC jacket). The fuse holder sockets are robust and hold the fuse plates very tightly, which means good electrical contact that won't loosen with vibration. The main body also has a 1/4" hole right in the center for attaching with a screw, mounting bolt or strap! The lid is thick and provides a good watertight seal. an extra fuse box from one…